Hi.
where should i do the editing so that when i am in the cab of EN57,i can everything including the speedo,throttle,brake meters and lever?I actually want to move the default position a little back.
There is a wall behind your back in the cab of EN57. The cab is a small place - then moving the default position of the driver to back is not up to the end possible.
However you can try it if you want. You must find a file
dynamic\PKP\EN57\6ba.mmd in your simulator folder and search in it for this:
cab1definition: //rozmiary kabiny po ktorej mozna chodzic
-1.4 1.4 8.9 1.4 1.4 9.8
This "
rozmiary kabiny po ktorej mozna chodzic" one could translate to "
sizes of the cab where you are able to move".
There is a six numbers - these are coordinates of two points, which are corners of the box of moving area:
[X1, Y1, Z1] -
[X2, Y2, Z2] respect to its center. Experiment with these numbers and you'll see that your moving area will change.
There is second place in the file
dynamic\PKP\EN57\6ba.mmd to experiment, too:
driver1pos: // pozycja poczatkowa
-0.6 2.7 8.9
This is a starting position:
[X, Y, Z] of the driver in the cab.
Sorry of my weak English language, but I think you understand me ;-).
Greetings.