MaSzyna International > EU07 Simulator English forum
SRJP timetables
Lelek:
I've changed the shift and now it's working.
Edit:
Now I'm doing dynamic timetable for Baltyk interregio. On relation Alakowice -> B. Miasto everything goes well. In Miasto, I get new timetable for opposite direction by "Timetable:" command with values 0.1 0. When I leave the station, B. Miasto disappear from timetable, but after passing B. Katedra it stops work. When train is waiting for departure from Miasto in direction of Alakowice, it has in scan table still W4 for original direction. Also after departure, in scan table are all the time the same elements, probably in direction B. Maisto -> B. Plaza.
Ra:
When a train end its timetable, the table from [F3] view should disappear and mode seen on [F2] should be changed from Obey_train into Shunt. An asterisk (*) can be added into description of last station, what should cause direction change of EZT or disconnection in case of locomotive and cars. In Shunt mode AI scans signals in both directions (unlike Obey_train mode) and changes the main direction if a shunting signal is set on its back. The other way is to put Shunt 0 0 disconnection command into memcell of a semaphore (as is done for ET22 in Dejawy on Quark).
muri:
Just for curiousity: what would happen, if AI is in shunt mode, and there are MS2 signals on both ends of the track?
Ra:
This is not specified. The main scanning is in recently used direction. The backward scanning is active only if AI stops (or sees W5 and goes behind last switch) and is performed just after the forward scan returns stop. So the forward signal will be seen first, as the signals cannot change while AI consciousness flash. If there's a small time gap between signals, and the back signal is first, AI may see it before the front signal.
Nawigacja
Idź do wersji pełnej