MaSzyna International > EU07 Simulator English forum

 New Routeeeeeeeeeeeeeeee!

(1/6) > >>

Anonymous:
I've install the new route, but i can't play it! Please help me!

Winger:
How can you expect for anyone to help you if you didn't wrote a single detail about your problem?

Write what route, what version of simulator do you have, what patches, what is the exact error message, what shows end of log file...

Without these (at least), nobody will be able to help.

Balage:
Hi,

I have the same problem. I installed the ns scenery and:
- if I started the EU 07-503 train activity, there was no overhead wire in the station. So if I tried to rise the pantograph ("O") it rose and fall back. So I got no electricity, no air pressure, etc. I could not move the train.
- if I started the EN 57 train activity, I presumably got the overhead electricity (no wires seen either), because the air compressor started, but I could still not move the train. (I pressed "O" then "M" then "X" then "C" then "," then "D" then "+", but that's it. Even if I waited long enough between the buttons)

Thank you for any advise:

Balage

Bartek:
The Nowy Swiat - Krosowo scenery is somehow original: it has NO wires. So when you start it pantographs are already up, you should process standard procedure without rising the pantographs (so, Shift + M, Shift + X, Shift + C etc.).

Balage:
Interesting, what you say, Bartek.
But the problem still exists.

At the EU 07-503 activity no pantograph is in up position if you start. You can clearly see it, if you move to the back wall of the cabine (down arrow) and turn. If you try to rise it, it will fall back as described before. You can check, wether there is any power coming in by looking at the right voltige meter. It stands on zero volts.
If you don't try to rise the pantograph, just push "M", the blue light appears. Then if you push "X" the right swich of the first row on the table jumps over. Then if you push "C" nothing happens. No swich moves, no sound to be heard, the air pressure does not change.
However, if you push the "V" button, a sound of something appears, but nothing changes. The sound keeps on, even if you turn off the main circuit "m". After a wile, the sound stops similarly to a compressor stopping. No idea, what it could be.
But as I told, no sign of power on the engine, so the compressor does not start and no power to move.

Any idea?

Balage

Nawigacja

[0] Indeks wiadomości

[#] Następna strona